• 2 steel spacers
• Hardware for connecting to lower bracket and air spring
• Detailed installation guide

• Works with all LoadLifter 5000 series and LoadLifter 7500 XL kits

Determine the Correct Lift Spacer

CAUTION THESE ARE UNIVERSAL KITS AND MAY NOT WORK ON EVERY APPLICATION.

Air Lift lift spacers can be used with LoadLifter 5000 and 7500XL kits to provide the benefits of air suspension for lifted vehicles.

Do not assume that a 6” lift kit will require a 6” lift spacer. On many lift kits, the lift for the front end is higher than for the rear. In this case, the lift might be labeled as a 6”, but the rear lift may only be 4”. Contact the lift kit manufacturer for the height increase of the rear. Choose the spacer that is closest to the increased amount of the lift for the rear of the truck. It is preferred to mount the air spring taller — or slightly stretched — than shorter — or slightly compressed.

Air Lift company recommends to read installation manuals for the lift kit and the load assist kit to fully understand the interfaces between the two products prior to purchasing.

A second method for determining which lift spacer is needed is to measure between the mounting surfaces of the upper and lower brackets (Fig. 1), then subtract the height of the air spring at design height (Table 1). Choose the lift spacer kit with the appropriate height and angle (Table 2). Take all measurements at curb height (flat surface, no load).

Fig. 1

Determine Height of Air Spring